Menu Content/Inhalt
Bass Defret - Tools  E-mail

How To Defret A Bass Guitar
Tools Required

Highland Woodworking Link

Tools Required:

  • Hardwood Veneer .023"
  • Wood Glue
  • Flush-Bottomed End Nippers
  • X-acto Saw .022"
  • X-acto Knife
  • Electrical Tape
  • Truss Rod Tool
  • Radius Block (Not necessary if you sand carefully and maintain the radius)
  • Sanding Block
  • Various Grits Of Sand Paper (150, 180, 216, 400, 600, #000 Steel Wool)
  • Straight Edge
  • Polyurethane (spray, wipe-on, brush-on, your choice. Tools to apply poly.)

       

 

Necessary Disclaimer

These instructions assume that you have sufficient expertise to use these tools and to perform the procedures contained in these instructions. If you are not certain that you can complete these steps, do not proceed, and take your project to a qualified person for this procedure. The author cannot be held responsible for your actions regarding these instructions, and your interpretation of the steps contained herein. You, the reader assume all responsibility for your instrument, and the results of your choices including, but not limited to, any injury or damages incurred as a result of following these instructions. By following these instructions, you agree to release all responsibility and liability from the author, and from ultimateguitartone.com.
 
[ Back ]